Hello Chantel!

Thank you for letting me build your keyboard. This page exist as a resource for you to assist in using your new keeb and to give you a personalized insight into the whole process. Of course for any problems or issues you may encounter, hit me up.

Your keeb is a NEO Palette G67, Ripple variant. It weighs 0.66kg.

The board you have received has the following specs:


  • DCS Sleeper + Geekark BoW Accents


  • Gateron Cap Golden Yellow


  • KBDfans
  • Housing lubed with Krytox GPL 205G0
  • Wires lubed with dielectric grease


  • Hotswap
  • Per-key RGB lighting
  • QMK firmware with VIA support


  • Carbon fibre plate

Build notes:

The firmware was updated via QMK to fully support VIA for keymapping. With no personal preferences provided, I went with the Gateron Caps as it was lubricated out of the factory.

Default (first layer) keymap. Keep in mind that this keyboard can be programmed in any way you wish, see the resources section or it is really for me to do it for you.

The second layer contains additional key binding, including media and lighting control. To activate these functions, press and hold the MO(1) key (right hand side of the r-alt key) along with the following keys, nothing that the triangle sign denotes that the second layer is the same as the first.

Please note the lighting control commands:

  • RGBTggl: light on/off
  • RGBMd-: previous lighting mode
  • RGBMd+: next lighting mode
  • Hue –: decrease hue (change primary colour)
  • Hue +: increase hue (change primary colourr)
  • RGB SPD: decrease effect speed (only for certain modes)
  • RGB SPI: increase effect speed (only for certain modes)